Trying Again – Core Shaker

This one is a bit of a challenge… After learning more about how to control some of the variables, I’m trying again. All it needs to do is stick to the plate & not warp!

20130915-144502.jpg

Update:  Unfortunately, after approximately 6 hours of printing, I came to the realization that this print was doomed.  Although not as severe as before, two of the corners started to lift & warp.  Because of the tolerances required of this part, this would impair its function.

Back to the drawing board – the next approach will be to design this part in separate pieces, which I’ll glue together after they’re printed.  So, the entire assembly will require 9 pieces – 4 for each section of the two trays and 1 for the case that will hold the two trays.

facebooktwittergoogle_plusredditpinterestlinkedinmail

Leave a Reply